Overview
Turbo TeeJet Induction Flat Spray Nozzles - TTI
Overview
Product Description
Recently, the United States EPA approved Monsanto's new Dicamba-based herbicide called XtendiMax for over-the-crop application in soybeans and cotton. The approval included specifications of the TTI11004-VP Turbo TeeJet Induction Nozzle as the only spray nozzle approved for this new application of XtendiMax, mainly from the nozzle's extremely low level of driftable droplets that were required for the success of this new formulation.
Monsanto anticipates a widespread adoption of XtendiMax across the United States in the near future, and the extensive field testing done has shown that the TTI-VP Turbo Induction Broadcast Nozzles provide exceptional drift control and weed control efficacy with XtendiMax.
These Turbo TeeJet Induction TTI Flat Spray Nozzles are made with polymer material for excellent chemical and wear resistance and are Visiflo color-coded for easy identification. They can be used to handle a range of chemicals, including soil applied and systemic herbicides, as well as systemic fungicides and insecticides. Depending on the chemical used, these broadcast spray nozzles produce large air-filled drops through a Venturi air aspirator which results in a reduction in drift.
Features:
- 110° wide angle spray angle
- Tapered flat spray pattern
- Operating Range: 15-100 PSI
- Polymer construction for chemical and wear resistance
- Visiflo-color coded for easy identification
- Orifice design minimizes plugging
- Compact size prevents tip damage
- Pre-orifice is removable
- Perfect for use with automatic sprayer controllers
- Recommended to space the nozzles 20" apart and not higher than 24" above crop canopy
- Approved for use with Engenia Herbicide
- TTI11004-VP is the only spray tip approved for Monsanto's XtendiMax Herbicide
Note: Due to the pre-orifice design of these Turbo TeeJet Induction Flat TTI Nozzles, they are not compatible with the 4193A check valve tip strainer.
Strainer Recommendations:
- 100 mesh strainer for TTI110015-VP
- 50 mesh strainer for TTI11002-VP to TTI11006-VP
Nozzle Cap Recommendations for automatic spray alignment:
- Quick TeeJet Cap CP114442A-1-CE (CP25598)
Please see Related Products for more information about strainers and nozzle caps.
See the Resources section for the capacity chart and more information about these Turbo TeeJet Induction Flat Nozzles.
Pulse Width Modulation (PWM):
Make every drop count with your PWM control. PWM spray tip control systems, like DynaJet, use a PWM valve located at the nozzle body to adjust spray tip flow rate when changes in speed are detected. Spray tips paired with PWM controls are serving two main purposes: the formation of the spray pattern and droplet size. Target droplet size selection should be based on providing enough coverage for proper pest control while balancing out the need for drift management.
With air induction tips, air is mixed with water through a venturi air aspirator that produces large air-filled droplets. When a PWM valve is used together with certain air induction tips, the mixing chamber and air inlet can fill with water as the PWM valve cycles. This can then result in water escaping out the air inlet holes, which can lead to poor distribution. New designs in air-induction tips have been proven to work well with PWM valves and nozzle control systems.
Based on a combination of field and laboratory testing, PWM approved spray tips must meet the following criteria at a variety of duty-cycles:
- Excellent spray distribution across the boom
- Skip-free application
- Excellent spray distribution in the direction of travel
- Rapid and complete spray pattern formation
- Droplet size consistency