Engine Hour Maintenance Meter

Monitor the run time, RPMs, and maintenance requirements on gasoline engines with this GDI Surface Mounted Engine Hour Maintenance Meter (# RHM/T).

Considered the perfect maintenance solution to monitor and properly maintain any gas-powered equipment, this meter is highly customizable and features functions such as an hour meter, automatic service alert with break in intervals, cycle counter, power UP/DOWN message, and more. All GDI surface mounted hour meters utilize a patented 1-wire hook-up which makes installation fast and easy.

With the GDI 'Flash Alert' system, the LCD display will flash what service to perform and when to perform it. The user is able to see how many hours are remaining until service is required, or if a service is required ASAP. The alert intervals reset automatically after the specified warning time out. Up to three 'Flash Alerts' with break in intervals are available.

NOTE: Requires a drill, 7/64" bit, and Philips screwdriver.

Features:

• For all 1 and 2 cylinder gas-powered engines
• Surface mounted hour meter records the total run time of the engine
• Tracks maintenance on any gas-powered engine
• Helps extend the life of your gas-powered equipment
• 3 x automatic service alerts with break in interval and reset options
• Inductive tachometer for 1 and 2 cylinder gas engines
• Easy to install
• LCD display stays lit
• Total run timer counts in tenths to 9,999.9, then whole hours up to 99,999 hours (not resettable)
• Patented 1-wire hook-up
• No battery required (wires to spark plug on the engine)
• Includes hardware
• 100% environmentally sealed
• CE approved
• Can be used for walk-behind and riding lawn mowers, ZTRs (all makes), garden tractors, motorcycles, jet skis, ATVs, and more

Installation Instructions:

1. Pull wire through meter from bottom. Place wire end into dead end hole and pull from bottom until tight. Do not strip the wire.
2. Spark Plug: Wrap the meter pick-up wire around spark plug wire 4-5 times. Secure with the supplied tie-wrap.
3. Coil Over: Wrap the meter pick-up wire around the coil 3 or 5 times. Secure with the supplied tie-wrap.

Installation Note: Mount using sheet metal screws or double-sided tape. The mounting location should not exceed 150° F (65° C). Never drill or puncture gas tanks, fuel lines, or any other hazardous material containers.